SKF TMMD Deep Groove Ball Bearing Puller Kit, 100 t Capacity, MFR ID 85HFR60
- EIS #TMMD100
- Series #TMMD
- UPC #07316572332573
$3,452.38 / Kit
Available to Order
Min QTY1QTY Increment1more info
The SKF TMMD 100 is especially designed to allow easy and quick dismounting of deep groove ball bearings with interference fit on both rings. The puller is suitable for use in both blind housings and shaft applications. In addition to dismounting open bearings, the TMMD 100 can be used to dismount sealed bearings after the removal of the seal. - SKF TMMD Deep Groove Ball Bearing Puller Kit.
Features
- The claws are especially designed to facilitate a precise fit in the bearing's raceways, providing good grip and allowing the application of higher dismounting forces
- Each puller arm is fitted with a spring for easy installation
- The puller arms are made of a single piece, laser-cut hardened-steel for strength and longevity
- Arm sizes 4, 5 and 6 are fitted with filling plates to accommodate a wide range of bearings
- The hexagon head of the spindle is equipped with an anti-slip pin, which prevents the spanner from sliding down the spindle during dismounting
- The rotation angle of the claw has been limited to allow easy insertion
- The designation is laser-engraved on the arms allowing easy identification and selection
- Content: (3) puller arm A1 5.3 Inch, (3) puller arm A2 5.3 Inch, (3) puller arm A3 5.4 Inch, (3) puller arm A4 6.4 Inch, (3) puller arm A5 6.6 Inch, (3) puller arm A6 6.7 Inch, (2) spindle, (1) nut, (1) handle
- 20.9 x 3.4 x 7 Inch dimension
- 5.3 - 5.7 Inch effective arm length
General Information
| Item Name | Deep Groove Ball Bearing Puller Kit |
| Series | TMMD |
Design & Construction
| Capacity | 100 t |
Documents
No Documents Found