MFR #:SE 9189 L GRAY 120
EIS #:DCSE9189LX120G
Series #:SE9189
MFR #:SE 9189 L GRAY 120
EIS #:DCSE9189LX120G
Series #:SE9189
Out of Stock
Min Qty:1
|Qty Increment:1
more info
Dow Corning one-part moisture cure adhesives are generally cured at room temperature and in an environment of 30 - 80% relative humidity eliminating the need for curing ovens and the associated costs of energy and capital. These adhesives are not typically used in highly confined spaces or where a deep section cure is required as they generally cure from the exposed surface inward at a rate of 0.25 Inch per seven days. Cure progresses from the outer exposed surface and is dependent on the moisture in the air. - Greater than 90% of full physical properties should be varies according to product. Faster attained within 24 to 72 hr and typical properties, continued Property Unit Value Dielectric Constant at 1MHz (JIS K 6249) - 3.1 Dissipation Factor at 1MHz (JIS K 6249) - 0.0004 UL Flammability Classification NA 94 V-0 manufacturing throughput can be achieved since the adhesive and component can be handled in much shorter times of about 10 to 120 min, depending on the adhesive selected and the amount applied.
Requires Quote / TUBE
Min Qty:1
|Qty Increment:1
more info
Dow Corning one-part moisture cure adhesives are generally cured at room temperature and in an environment of 30 - 80% relative humidity eliminating the need for curing ovens and the associated costs of energy and capital. These adhesives are not typically used in highly confined spaces or where a deep section cure is required as they generally cure from the exposed surface inward at a rate of 0.25 Inch per seven days. Cure progresses from the outer exposed surface and is dependent on the moisture in the air. - Greater than 90% of full physical properties should be varies according to product. Faster attained within 24 to 72 hr and typical properties, continued Property Unit Value Dielectric Constant at 1MHz (JIS K 6249) - 3.1 Dissipation Factor at 1MHz (JIS K 6249) - 0.0004 UL Flammability Classification NA 94 V-0 manufacturing throughput can be achieved since the adhesive and component can be handled in much shorter times of about 10 to 120 min, depending on the adhesive selected and the amount applied.
- Attributes
- Features
Attributes
General Information
Item NameConformal Coating
SeriesSE9189
General Features
TypeFast Tack
Design & Construction
ColorGray
Cure TypeRTV
FormLiquid
Performance Details
Tensile Strength284 psi
Application Time8 min
Full Cure Time24 - 72 hr
Chemical Properties
CompositionPolydimethyl Siloxane
Specific Gravity1.18
Viscosity22000 cP
Electrical Properties
Dielectric Strength625V/Mil
Physical Properties
Container Size120g
Container TypeTube
Elongation235%
Hardness33 Shore A
Odor/ScentSlight
Environmental Condition
Temperature Rating-45 to 200 °C
Features
- Fast tack free room temperature cure
- Flowable
- Cures to soft, low stress elastomer
- Pigmented to hinder component identification
- Controlled silicone volatility
- No added solvents
- Room temperature cure, no ovens required
- Mild heat acceleration can speed in-line processing
- Soft coating can improve reliability against stress
- Can be considered for uses requiring added flame resistance